How to Install Cable
DIY instructions on how to install cable for the Benner Deer Fence Co. Professional System. Use this method for all horizontal tension cable installation.
Run Cable
Slide cable through each eye bolt or post cap in stretches up to 200 ft.
Terminate Cable
Cut the cable, leaving approximately 2 ft. of extra cable. Use a gripple to fasten. Slide the cable into the fastener following the arrows on the gripple. Do not tighten yet. Repeat this step at the starting point.
-
8 GAUGE METAL CABLE: Metal cable is used for the bottom cable because it can not be chewed through.
8 GAUGE NYLON CABLE: The thicker cable is used for the top cable to support the weight of the fence.
12 gauge nylon cable: The thinner cable is used for the middle cable.
NOTE: Some kits may only come with one type of cable.
-
Begin and terminate all cable at a braced, cemented, or tree post whenever possible.
-
MEDIUM GRIPPLE: secures 12 gauge cable (thinner cable).
LARGE GRIPPLE: secures 8 gauge metal and nylon cable (thicker cable).
Tighten cable
Tighten both ends by holding the fastener in one hand and pulling the cable with pliers in the opposite direction.
U-bolt Cable Connector
U-bolt cable connectors can be used at one end of cable termination to terminate cable. The other end of the cable termination needs to be a gripple so that tension can be applied.
-
For extra tightening, raise the fastener up and pull the cable through.
-
Use 2 u-bolt cable connectors to splice two ends of cable together.